[Chevymanrc]

I tried this and the rear tires ended up having a smaller diameter due to the width of the rear rims. Ended up grabbing two more fronts to complete the square set up.
....and it looked weird!

Camshaft, i followed your direction and found 2 front stock wheels to square up my rmax4. Do you think there is room for a 32x10x14 XTR370 to clear in the rear? I know your 30x10x14s look pretty tight in the above picture but not sure how each brand of tire "actually" measures in real life. I don't mind some slight rubbing at max capacity (especially if its not hurting the tire or machine) but would prefer not to have any.
Thanks

 

[Chevymanrc]

I ended up putting more aggressive tires on a short time ago that may measure a bit taller. I'll take another measurement tonght or tomorrow am for you.

Thanks man. You have any pics? I'm guessing you kept the oem wheels with the new setup as well?

 

[Chevymanrc]

I'm gonna be due some new rubber before too long. I was leaning towards the Roxzillas but the terrain I am always in doesn't look to be the best for those tires from what I've seen. So...I'm back on the hunt. I'd like to put bead locks on there as well so I can get the pressures on down without it being a problem. I think the quest for THE tire is never-ending.

I've been looking at this setup but am lost on the offset...they say they fit the '21 RMAX2...they say..

View attachment 109864

That 6+1 offset is going to have your tires tucked in under the machine. A 5+2 would be closer to stock and a 4+3 would be wider than stock.