Joined
·
575 Posts
I had to go etch a plexiglass plate so while next to the wolverine took some cardboard and decided to do a raw mockup of the door design I posted previously.
Keep in mind this is a very raw mockup.
About 4in more knee room due to the door flaring out.
With the flare the door would still fit within the tire track width.
Next step, is to tighten up the gaps and make the template .. Still not 100% decide on making the doors just yet..
I need to find someone to fab the frames, or decide if I will take it on.
Keep in mind this is a very raw mockup.

About 4in more knee room due to the door flaring out.

With the flare the door would still fit within the tire track width.

Next step, is to tighten up the gaps and make the template .. Still not 100% decide on making the doors just yet..
I need to find someone to fab the frames, or decide if I will take it on.