[DrJ]

So, I found and cleaned the two grease zerks/fittings tucked in behind each rear wheel. However, given their placement & angle, I can't get my grease gun flexible hose/ending onto these fittings. So, what's the secret that you guys know but I obviously don't!

Thanks.

DrJ

 

[PapaSkeeta]

This thread has some information. http://www.wolverineforums.com/forum/9-wolverine-general-discussion/5625-grease-fittings-2.html Page 1 has various methods, on page 2 what I did to simplify the process for future greasing.

 

[Ducknap1965]

I used a 90 degree grease needle. I held the needle while my girlfriend worked the grease gun.

 

[Doc T]

Yep, The girlfriend is the best way to do it

 

[Vtalen]

Just did mine for first time today. Used a needle tip from tractor supply. Worked ok. I found the hardest one was rear of front drive shaft. Only one though I didn't use needle on