Yamaha Wolverine Forum banner
1 - 1 of 1 Posts

·
Registered
2022 Rmax sport
Joined
·
1,345 Posts
Pretty easy so this may be redundant but figured you need to drill and removing old links can be stubborn.

Tools-
Ratchet & wrenches - 13, 14, 16, 17, 19mm
1/2“ Drill bit
5mm Allen key

Started with the rear, remove old links with 2x 17mm. Good chance loosening the bolt spins the threads, grab another 17mm wrench and use the slots between washer and bushing.

View attachment 105905

Admire new links compared to old (slightly shorter & seem stiffer)

View attachment 105906

Jack up vehicle, remove tires - this was needed for my drill to fit, some may not need to do so.

Use 1/2“ bit to widen lower attachment point on control arm-

View attachment 105909

Cover area and dab exposed metal with paint

View attachment 105907

Install New hardware with 16mm & 19mm

View attachment 105911

Reisntall tires and lower vehicle. New links can be attached when both sides are level, can easily rock vehicle if not quite lined up or pull on roll cage to shift weight.

View attachment 105912

the front is pretty straight forward. Remove factory links with 17mm. If the threads spin use 5mm in thread ends to start removing nut. Once you get enough room or if you want to avoid strip the Allen key it may be easier using a 14mm as pictured below

View attachment 105913

Install new hardware with 13mm & 14mm

View attachment 105914

Install links and enjoy!

View attachment 105915

I’ve found when installed they seem stiffer and induce less body roll on turn in, this translates to breaking traction faster when rallying so pretty fun. Once removed its Excellent on the trail. Each side it working independently and do a better job soaking up bumps and whoops. Much less teeter tottering crossing obstacles and climbing/crawling. The front being removed is noticeable above 30 or so but left the rear off and still pretty stable. If you don’t goof off on dirt roads much and only trail ride id only go for the quick disconnect in the front and run no rear at all.
Very nice 👍Let the picture do the talking.
Tire Wheel Vehicle Car Automotive tire
Tire Vehicle Wheel Hood Car
 
1 - 1 of 1 Posts
Top