Yamaha Wolverine Forum banner


2434 Views 4 Replies 5 Participants Last post by  DJPainter
Last few times out to tower trax i started having an issue with my wolverine dying when i let it idle down to put it in reverse, always happens in low rpm situations and when the bike is at an angle. Any ideas?
1 - 5 of 5 Posts
mine dies at idle sometimes too.
cause they set them so lean from factory. fuel programmer wil fix it
  • Like
Reactions: 1
I have a problem, when it gets warmed up it misses and won't run over 30. It surges from power to no power, back and forth. If you stop for 5 minutes and restart it it goes like nuts for a little bit then does it again, over and over. Any ideas?
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.