Yamaha Wolverine Forum banner
1 - 2 of 2 Posts

·
Registered
2020 X2 XTR
Joined
·
204 Posts
Discussion Starter · #1 ·
After putting on my square setup on the rig and 1500+ miles I have some spring sag and want to straighten the lean out on the tires and get my ride height back but have never done this.
The measurements they show in the manual are those with the weight on or off the machine? I know each revolution of the nut is .06”. With the weight on the machine my front springs are sitting at 11.250”.

Probably over thinking again and making it harder than it is 😆

Tire Sky Wheel Vehicle Car
 

·
Registered
Joined
·
3,493 Posts
Here’s a little info to read that may help ya!
 
1 - 2 of 2 Posts
Top