View Profile: Mud rat - Yamaha Wolverine Forum
Login to Your Account
Yamaha Wolverine Forum
Tab Content
No Recent Activity

3 Visitor Messages

  1. Soi just finished the install of the prefix 2' lift have to say it was really simple only difficult thing was the small nut up next to the bed. I'm trying to decide on new tires and rims now I like the Sedona rip saws or the mud lights 28x12 front 28x14 rear will either rub any where I also noticed that after the lift install it looks like I lost a few inches of width so what off set are must guys using?? I ride in North Dakota so have a little of everything mud hardback rocks hills prairie o yeah and snow just looking for some input so I get the right set up Got a thaw going on right now so I'm going to go out this weekend and try out the new lift and getter MUDDY
  2. So I'm back I just finished up installing the prefix 2' lift it wasn't that bad only thing difficult was the back left side up against the bed. My question is I like the Sedona rip saw or the mud lights in a 28 x12 front and 28x14 rear will they rub . After the lift install it looks like it lost a few inches of width so how much off set are most guys going with. I ride in North Dakota so we get a mix of everything here mud hard pack rocks hills and flat prairie o yeah and snow.
  3. New member. Looking to put new tires and rims on. Have a 2 inch lift to install this spring like the mud lights 28 on 14 inch rims First question is will they fit with out rubbing and 2 will I need off set to not rub on the inside while turning. Thx
Showing Visitor Messages 1 to 3 of 3
About Mud rat

Basic Information


Total Posts
Total Posts
Posts Per Day
Visitor Messages
Total Messages
Most Recent Message
04-19-2018 01:35 PM
General Information
Last Activity
04-17-2019 10:44 AM
Join Date
0 is an independent Yamaha enthusiast website. Content on is generated by its users and is not in any way affiliated with Yamaha Motor Corporation, U.S.A.