I have a spanner wrench that is about 4" long with a 3/8" square drive that I think I got from Rocky MtATV several years back. I use the blunt chisel...
If you want to use a string I suggest two strings, one on each side be set up and set parallel with the frame. Then you can measure to each point on...
I put a long straightedge across each front tire parallel to the ground and adjusted each tie-rod until the distance from a point on the frame to the...
Its been quite a while, but putting a straight edge against each tire and measuring the difference between the front and rear of the FRONT tires only...
WolverineForums.com is an independent Yamaha enthusiast website. Content on WolverineForums.com is generated by its users and WolverineForums.com is not in any way affiliated with Yamaha Motor Corporation, U.S.A.