This is a discussion on Seat belt bracket for clutch cover removal. within the X2/X4 CVT, Sheaves & Wet Clutch forums, part of the Yamaha Wolverine X2 & X4 847cc SxS category; So instead of dealing with the hassle of removing my seat brackets for clutch cover removal I came up with this method. Cut off the ...
So instead of dealing with the hassle of removing my seat brackets for clutch cover removal I came up with this method.
Cut off the seat bolt bracket as shown then installed a bracket with two bolts and nylon nuts. Takes two minutes to removed the bracket and the cover comes off with all the room you need with seat brackets in place.
Too bad Yamaha didn’t think of this. Much easier if they had a removable bracket for the seat belt. I like to work smarter not harder. Lol
Sent from my iPhone using Tapatalk
2019 Wolverine X2 Camo R-Spec
1st Wolverine X2 ECU Tuned by Dynojet with PV3 and HMF QS
HW w/20's with blow out port
MSA M25 Wheels w/ EFX 8ply 27x10x14 Motoclaw with SATV 1.5" Rear Wheel Spacer
SATV Flip Windshield & Half
SATV 72" Plow
Pro Vantage 3500 Warn
Rear Cargo Box
Adventure Pro Magellan
50" XPRITE LED light bar
WeBoost 4G-X OTR
Shoulder bolster deleted
EMP side mirrors
28K BTU in Cab Heater
SxS Enclosures full Cab
NGK Iridium Plugs