Stereo Mounting - Page 2
Close
Login to Your Account
Yamaha Wolverine Forum

Stereo Mounting

This is a discussion on Stereo Mounting within the Audio, Lighting and Electrical forums, part of the General Discussions category; Originally Posted by Happycamper08 What amp and speakers are you going with? From what I saw in the spec's this one and others similar (at ...

Page 2 of 2 FirstFirst 1 2
Results 11 to 15 of 15
Like Tree9Likes

Thread: Stereo Mounting

  1. #11
    Cannon Ball
    Member #
    15104
    Join Date
    Dec 2018
    Posts
    698
    Member #
    15104
    Liked
    215 times
    Quote Originally Posted by Happycamper08 View Post
    What amp and speakers are you going with?
    From what I saw in the spec's this one and others similar (at least two others) have built in amps. I know the BOSS specifically said it supported two external amps. But going with any external amp is going to be a big power hit for the charging system. Its a stator and limited capacity for accessories full time running.
    2017 Wolverine RSPec SE
    Belleville, Ont. Canada

    BigHorn 2.0 27 inch tires
    Half windshield
    Roof
    Aluminum Under armor
    Yamaha Warn 3500lb Winch & Synthetic rope

  2. #12
    Experienced Piston Yamaha's Avatar
    Member #
    14522
    Join Date
    Jul 2018
    Location
    Michigan
    Posts
    509
    Member #
    14522
    Liked
    377 times
    Quote Originally Posted by Piston Yamaha View Post
    Thanks. It's in now and is solid like you said.

    Attachment 73570
    I'm not using an amp and I'm going with Pyle 6.5 Marine Speakers. Right now, I have my old Clarion marine speakers in there, but they lack bass.
    Wolverine X2 R-Spec SE
    27" Big Horn 2s, SuperATV Flip Windshield, Yamaha Soft Cab, Yamaha Cargo Box, Kolpin 3500# winch w/ synthetic rope, KFI winch mount, UPI Inferno Heater, JBL PRV-175 stereo, Polk 6.5 speakers, Garmin Drive 60 with VV Mapping. Lots of other little things.

  3. #13
    Experienced Piston Yamaha's Avatar
    Member #
    14522
    Join Date
    Jul 2018
    Location
    Michigan
    Posts
    509
    Member #
    14522
    Liked
    377 times
    Quote Originally Posted by Piston Yamaha View Post
    I'm not using an amp and I'm going with Pyle 6.5 Marine Speakers. Right now, I have my old Clarion marine speakers in there, but they lack bass.
    I used the Clarions for a bit and finally built a box for them. They were actually pretty good in the box but I still upgraded to the Polk 6.5s. I typed Pyle up above by mistake. The Polks are much better.

    Name:  20190525_173612.jpg
Views: 28
Size:  1.28 MB
    Tnx2 likes this.
    Wolverine X2 R-Spec SE
    27" Big Horn 2s, SuperATV Flip Windshield, Yamaha Soft Cab, Yamaha Cargo Box, Kolpin 3500# winch w/ synthetic rope, KFI winch mount, UPI Inferno Heater, JBL PRV-175 stereo, Polk 6.5 speakers, Garmin Drive 60 with VV Mapping. Lots of other little things.

  4. Remove Advertisements
    WolverineForums.com
    Advertisements
     

  5. #14
    Hog Chaser BigRed's Avatar
    Member #
    15372
    Join Date
    Feb 2019
    Location
    Halifax, NS
    Posts
    53
    Member #
    15372
    Liked
    44 times
    i like that speaker set up. can you post more pics of how they are mounted.
    2019 X2
    oem full windshield
    soft rear window
    KFI stealth 3500 winch
    warn provantage plow
    auxbeam 32" light bar
    Little Trees pine air freshener.

  6. #15
    Experienced Piston Yamaha's Avatar
    Member #
    14522
    Join Date
    Jul 2018
    Location
    Michigan
    Posts
    509
    Member #
    14522
    Liked
    377 times
    Quote Originally Posted by BigRed View Post
    i like that speaker set up. can you post more pics of how they are mounted.
    There's a threaded mounting hole on each side of the ROPS where it's mounted. This box started out as a prototype for a better one I would build, but it ended up being good enough. The prototype had wooden tabs with holes drilled through them to mount to the mounting holes in the ROPS. The first pic is from the inside of the cab and shows the mounting holes. The second pic, you can see the wooden tabs on the speaker box. I knew those wouldn't hold up, so I added some steel mending plates for strength. You can see the mending plate in the second pic too. If I were build this again, I wouldn't cut the wooden tabs into the box and just used the mending plates.

    Name:  DSCN8035.JPG
Views: 21
Size:  3.55 MB

    Name:  DSCN8033.JPG
Views: 22
Size:  4.05 MB
    atkbike and TimBo like this.
    Wolverine X2 R-Spec SE
    27" Big Horn 2s, SuperATV Flip Windshield, Yamaha Soft Cab, Yamaha Cargo Box, Kolpin 3500# winch w/ synthetic rope, KFI winch mount, UPI Inferno Heater, JBL PRV-175 stereo, Polk 6.5 speakers, Garmin Drive 60 with VV Mapping. Lots of other little things.

Page 2 of 2 FirstFirst 1 2

Sponsored Links

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Similar Threads

  1. Wolverine stereo audio system?????
    By Mountain592 in forum Wolverine General Discussion
    Replies: 27
    Last Post: 02-22-2018, 05:53 PM
  2. Any suggestions on Bluetooth stereo/speakers?
    By Wolverine4SHR in forum Audio, Lighting and Electrical
    Replies: 0
    Last Post: 01-29-2017, 11:28 AM
  3. Winch, stereo, and switches installed
    By Big Dog Daddy in forum Audio, Lighting and Electrical
    Replies: 26
    Last Post: 02-24-2016, 05:20 AM
  4. Simple stereo build.
    By Bert in forum Wolverine Pictures / Videos
    Replies: 4
    Last Post: 02-06-2016, 04:39 AM
  5. Best Wolverine Stereo??
    By Tolliver in forum Audio, Lighting and Electrical
    Replies: 10
    Last Post: 06-06-2015, 12:15 PM
WolverineForums.com is an independent Yamaha enthusiast website. Content on WolverineForums.com is generated by its users and WolverineForums.com is not in any way affiliated with Yamaha Motor Corporation, U.S.A.